2 thoughts on “Hello December”

1. with the Balanset-1A Device

   Equipment Preparation

   • Ensure the instrument is complete with all necessary components: vibration transducers, laser tachometer, magnetic stand, software, and other accessories.
   • Set up the instrument and connect it to your computer via USB. Verify that the software is correctly installed.

   Setting Up the Sensors

   • Mount the vibration transducers securely on the machine's housing where vibrations are most pronounced, typically near the bearings.
   • Direct the laser speed sensor towards the rotor and affix reflective tape to the rotor surface to facilitate phase angle measurement.

   Launching the Software

   • Launch the Balanset software on your computer.
   • Choose the correct balancing method (single or two-plane) according to the rotor configuration and the balancing task.

   Initial Vibration Measurement

   

   • Bring the rotor to its normal operating rotational frequency.
   • The program will record the vibration amplitude, rpm, and phase, providing a baseline measurement of the existing imbalance.

   Trial Weight Installation

   

   • Stop the rotor and attach a trial weight at a specific location on the rotor. The weight's mass can be specified within the software (e.g., in grams).
   • Run the rotor again, allowing the software to measure the effects of the trial weight on vibration and phase.

   

   Computing the Compensating Weight

   • Based on the measured data, the software automatically calculates the correction weight parameters: mass and installation angle.
   • The results of the calculation are shown both numerically and visually through charts and graphs.

   

   Installing the Correction Weight

   • Mount the calculated corrective weight onto the rotor at the specified location and angle.
   • If necessary, perform intermediate checks to verify that the imbalance is being reduced.

   

   Validation and Conclusion of the Balancing Process

   • Once the corrective weight is in place, restart the rotor and measure the remaining vibration amplitude.
   • If the vibration level is within acceptable limits (according to ISO 1940), the balancing is complete.
   • If the vibration is still outside acceptable limits, reiterate the process and fine-tune the compensating weight.

   Creating a Balancing Report

   • The balancing results are saved in the software's archive. You can create and print a report containing vibration data, correction weight mass, and its installation angle.

   Final Recommendations

   • Verify the secure attachment of all balancing weights and measurement sensors.
   • Check that the rotor's rotation is smooth and free from undue noise or vibration.
   • If the rotor is part of a complex mechanism, verify the proper interaction of all its components.

   Following this procedure enables accurate balancing, minimizes vibration, and prolongs the service life of the equipment.

   Instagram: https://www.instagram.com/vibromera_ou/ Youtube : https://youtu.be/guA6XJ-ArZM?si=vmkuX7RILzKBl0zL Our website about Balancing of metallurgical equipment Machinio: https://www.machinio.com/listings/98380186-portable-balancer-vibration-analyzer-balanset-1a-full-kit-in-portugal Facebook: https://www.facebook.com/marketplace/item/350151228150722

   Reply

2. ? ????? Kraken ???? ???????????? ? confidentiality are in focus. ??? ??????-???????? offers convenient access ? various services, ??????? ??????????? maximum privacy. ????? ??????? ???????? ????????? ?? ?????????, ??? allows you freely use ????????-????????. Kraken ???????????

   Reply